What a size-class distribution actually is
A size-class distribution (some crews just call it the stand table's diameter column) is the count of stems in each diameter bucket, usually 2-inch DBH classes: 4-6", 6-8", 8-10", on up through the sawtimber classes. It's the one number set that tells you whether a stand is young and crowded, mature and spread out, or stacked in pulpwood-size stems with nothing coming up behind it.
Foresters pull it because it drives the call, not just the paperwork. A stand with 400 stems per acre crammed into the 4-8" classes needs a precommercial thin. A stand sitting in the 14-18" classes with thin recruitment behind it is ready to cut and needs regen money budgeted now, not after harvest. Total basal area alone won't tell you either of those things. You need the distribution.
Where that number usually comes from, and what can go wrong with it
Traditionally this means plots. A cruiser runs a grid of fixed-radius or variable-radius plots across the stand, tallies DBH on every tree in, applies a basal area factor, and blows the sample up to a per-acre stand table. It's the basis most cut estimates are still built on, and it works. But it's a sample. A 40-acre stand on a 5-acre grid is eight or nine plots standing in for the whole tract, and the size-class breakdown you walk away with is only as good as how representative those plot centers happened to land. Edge effect near a road, a patchy understory, a wet draw nobody wanted to walk into in July: any of it can skew a class or two without anyone knowing until the harvest tally comes back different than the cruise said it would.
Building the same table from crown size instead of plot tallies
Crown width and DBH move together. That's not new; foresters have used local crown-diameter-to-DBH equations for decades to back into a diameter estimate from aerial imagery, usually imagery too coarse to pick out individual crowns reliably once the canopy closes up.
A sub-10cm drone or aircraft pass changes what's actually resolvable. At that ground sample distance, individual crowns in a closed stand segment out one at a time instead of blurring into canopy texture. Every crown gets measured, so every stem runs through the local crown-to-DBH equation instead of just the ones that happened to fall inside a plot. Bin those diameter estimates into the same 2-inch classes a cruiser would use and the stand table builds itself from a full count, not a blown-up sample. No plot centers to argue about, no grid to walk, and what comes out the other end is stocking by size class for the entire stand instead of an extrapolation from a couple percent of it.
Ground calibration still matters. A crown-to-DBH equation needs local tree-form data to hold up on a given species mix and site, and a forester or project team supplies that for the tract before the imagery can be trusted. What changes is the sampling problem. Instead of deciding where eight plots go and hoping they're representative, the full-stand pass gives you every crown, and the size-class table comes from the whole population instead of a guess at it.
A stem-level crown inventory built from a sub-10cm annual pass applies this at the stand level: every crown segmented and sized, so the diameter distribution behind your cut estimate is counted, not sampled.
If your next cruise is really a question about stocking by size class, it's worth seeing what a full crown count gives you before the plots get walked.
